Wyvern
®
2000N Banknote Timer Handbook 5
With LKSW1 in the ON position press and hold both programming buttons for
approximately 5 seconds to enter the programming menu. Press and release the UP
button to access the option number required. To alter the program settings hold the
UP button for about 4 seconds until the option number flashes and use the UP and
DOWN buttons to change the value. Wait for approximately 10 seconds and a
“beep” for this value to be stored. To leave programming mode press and hold both
programming buttons for approximately 5 seconds. Return LKSW1 to the OFF
position for all settings to take effect.
Setting the Time of Day
A real-time clock is fitted to the Wyvern
®
2000N. Time is set using program code
d-. Once program code d- is selected, pressing the UP button will start to flash the
first two digits of the 4-digit display. The UP and DOWN buttons can be used to
set the first 2 digits to the required hours. Press and hold both programming buttons
for approximately 5 seconds until the last 2 digits flash when the UP and DOWN
buttons can be used to set these digits to the required minutes. The clock is set by
holding both programming buttons for approximately 5 seconds. The display then
shows Hr: and by using the UP or DOWN button can be toggled between 12 and 24
to allow selection of a 12 or 24 hour clock. Hold both programming buttons for
approximately 5 seconds to exit this option. If the real-time clock is not required set
the time to 00:00. This will not change the count-down operation of the display, but
once zero time has been reached the display will permanently display 00:00.
Session Time Per Note (STPN)
Program code 7 allows a period of time to be allocated to a particular note value.
Remember, these options must match the note order of the note value in option b.
Access the options menu as described earlier and using the UP and DOWN buttons
move to option 7. Hold the UP button until the first digit flashes and the display
shows 71:xx where xx is the time per note. The display will alternate between minutes
and seconds setting. Using the UP and DOWN buttons select the STPN program
Program
Code
Description
Maximum
Value
Value Used
d-
Setting the real-time clock
_