10
lci1.com
574-537-8900
Rev: 03.09.18
Solera
®
Destination Awning
Installation and Owner’s Manual
(For Aftermarket Application)
CCD-0001255
10�
Unroll the fabric from the roll tube to allow the drive/
idler head assemblies to be installed into the outer arms.
11�
Install the previously removed drive head assembly and
idler head assembly retaining bolts into the outer arms to
secure the components.
12�
Reinstall the previously-removed support arm upper
mounting bracket to the unit wall.
13�
Make sure the cam lock is in the roll out position and
remove cotter pins from the awning heads.
14�
Retract and extend the awning several times (see
Operation section of the manual) to ensure that the fabric
is square on the roll tube.
15�
Secure the fabric in the awning rail no more than 1
"
inside the edge of the fabric on both ends using a #6 x
1/2
"
hex head screw. Install the screw down through the awning
rail into the fabric and the polycord
(Fig.19)
.
16�
Reinstall the drip cap if previously equipped.
awning rail
1
"
fabric
stitching
Fig.19
Maintenance
Fabric Care
NOTE:
If the awning is retracted while wet, extend the
awning and let it dry as soon as conditions allow before
retracting. This will help prevent the formation of mildew
and add greatly to the life of the awning. Mildew does not
form on the fabric itself, but on the accumulated dust, dirt
and grime.
NOTE:
Note: Periodically clean vinyl or woven acrylic
fabric using a mixture of
1/4
cup of dish soap and 5 gallons
of warm water. Liberally apply the mixture on the top of the
fabric and retract the awning for 5 minutes. This will apply
the mixture to the bottom of the fabric as well. Extend the
awning and hose off with fresh water. Repeat if necessary.
Allow to dry before retracting.
FAILURE TO SUPPORT THE ROLL TUBE, FABRIC
AND DRIVE/IDLER HEAD ASSEMBLIES DURING
INSTALLATION MAY RESULT IN SERIOUS INJURY
OR PROPERTY DAMAGE�
Classic Awnings Fabric Replacement Turn Chart
9�
Working together, install the roll tube assembly (which
includes the drive/idler head assemblies) to the awning rail
by sliding the assembly along the awning rail. Make sure
the awning will unroll with the printed side of the fabric up.
