18
8.4. Installation of the crank (Fig.9)
Your device may be powered manually by you through the use of a crank. First, screw
two M8 nuts (item 11) onto the pivot arm of the drive, and then screw on the crank (item
10). Tighten the nut closest to the crank using the key tool that is provided in your kit.
Next, tighten the nut closest to the device. Tighten it so it is secure against the first nut.
This procedure ensures that the crank will not loosen and fall off during operation.
Fig.9 Installation of the crank for manual operation
8.5. Installation of the hexagonal shaft adapter (Fig.10)
In the event that you want to use a cordless power drill instead of the manual crank to drive
your device, you will install a hexagonal shaft adapter instead of the crank. If the crank
is installed, remove it before proceeding.
Screw two M8 nuts (item 11) onto the pivot arm of the drive, and then screw on the
hexagonal shaft adapter (item 12) after them. Tighten the nut closest to the hexagonal shaft
adapter with the key tool in your kit. Ensure that it is firmly against the hexagonal shaft
adapter. Tighten the second nut so it is secure against the first.
This procedure ensures that the hexagonal shaft adapter will not loosen and fall off during
the operation.
Fig.10 Installation of the hexagonal shaft adapter
Video #6: Installation of the crank
Video #7: Installation of the hexagonal shaft adapter
www.
bit.ly/lcm-instructions
