LBE ECOMAX Series, Руководство по эксплуатации

Страница: 4 / 18

GB-4
D
GB
F
NL
I
E
With ceramic radiant tube (SER-C)
Sicaflex
®
SER-C
FLUP
▷
The ceramic radiant tube (SER-C) must be cor-
rectly installed on the furnace before the burner
is installed, see www.docuthek.com
→ Elster
Kromschröder
→
Kromschröder, LBE
→
Prod-
ucts → 07 Pilot burners and burners → Self
recuperative burner ECOMAX ®
→
Radiant
tube SER-C → Operating instructions for ce-
ramic radiant tube SER-C
▷
Install the internal segmented flame tubes
SICAFLEX
® , see www.docuthek.com →
Elster Kromschröder
→
Kromschröder, LBE
→
Products → 07 Pilot burners and burners → Self
recuperative burner ECOMAX ® → Segmented
flame tube SICAFLEX ®
→
Operating instructions
for segmented flame tubes SICAFLEX ®
▷
Depending on the installation situation, a flue gas
guide tube FGT may be required, see page 14
(Accessories).
With metallic radiant tube (SER-M)
SER-M
FLUP
Sicaflex
®
With metallic radiant tube (SER-M) and
eductor
SER-M
EJEK
Sicaflex ®
▷
The metallic radiant tube (SER-M) must be cor-
rectly installed on the furnace before the burner
is installed. Ensure there is a good seal between
the furnace flange and SER-M.
▷
Install the internal segmented flame tubes
SICAFLEX
® , see www.docuthek.com → Elster
Kromschröder
→
Kromschröder, LBE
→
Prod-
ucts → 07 Pilot burners and burners → Self
recuperative burner ECOMAX ®
→
Segmented
flame tube SICAFLEX ®
→
Operating instructions
for segmented flame tubes SICAFLEX ®
▷
Depending on the installation situation, a flue gas
guide tube FGT kit or an adapter flange may be
required (available on request as accessories).
CAUTION
Danger of breakage. Avoid impacts when inserting
the burner into the ceramic radiant tube and placing
on the stud bolts.
 Remove the transport safety device.
 Slide the FGT over the burner recuperator if it
has not yet been installed.
5 6
3
7
4
If no seal is
fitted, fit a
seal.
▷
Tighten the nuts in two cycles in a crosswise
fashion, torque: 46 Nm.
▷
When installing, ensure that the components
are sealed tightly.
▷
Ensure that no lateral forces act on the burner
recuperator.
Heat guard
▷
During operation, the burner housing and educ-
tor or flue gas connector can reach surface tem-
peratures of over 80°C.
▷
We recommend that warning signs and a contact
guard be fitted, for example made of perforated
sheet metal.
▷
Do not insulate the burner, eductor and flue gas
connector to prevent material overheating.