Integration instructions for host product manufacturers according to KDB 996369 D03 OEM
Manual v01
2.2 List of applicable FCC rules
CFR 47 FCC PART 15 SUBPART C has been investigated. It is applicable to the modular transmitter
2.3 Specific operational use conditions
This
module
is
stand-alone
modular.
If
the
end
product
will
involve
the
Multiple
simultaneously
transmitting
condition
or
different
operational conditions for a stand-alone modular transmitter in a host, host manufacturer have to consult with module manufacturer
for the installation method in end system.
2.4
Limited
module
procedures
This module is Limited single modular without shielding, host manufacturer have to consult with module manufacturer for the module
limiting conditions when integrate the module in the host. module manufacturer should reviews detailed test data or host designs prior
to giving the host manufacturer approval.
2.5 Trace antenna designs
Not applicable
2.6 RF exposure considerations
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the radiator & your body.
2.7 Antennas
This radio transmitter
2AL6KBL-M8821CU1
has been approved by Federal Communications Commission to operate with the
antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a
gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with this device.
Model
Type
Connector
Peak gain ( dBi )
2400-2483.5
MHz
5150-5250
MHz
5250-5350
MHz
5470-5725
MHz
5725-5850
MHz
2400-2483.5
MHz
P
IFA/
Dipole
/
2.0dBi
/
/
/
/
2.4GWIFI
P
IFA/
Dipole
/
2.0dBi
/
/
/
/
5GWIFI
P
IFA/
Dipole
/
/
2.0dBi
/
/
2.0dBi
2.8
Label
and
compliance
information
The final end product must be labeled
in
a visible area with the following" Contains FCC ID:
2AL6KBL-M8821CU1
".
2.9 Information on test modes and additional testing requirements
Host Host manufacturer which install this modular with limit modular approval should perform the test of radiated emission and
spurious emission according to FCC part 15C:15.247&FCC part 15E:15.407 and 15.209
requirement, only if the test result comply
with FCC part 15.247&FCC part 15E:15.407 and 15.209
requirement, then the host can be sold legally.
2.10
Additional testing,
Part
15
Subpart B disclaimer
Host manufacturer is responsible for compliance of the host system
with module
installed with all other applicable
requirements for
the system
such as Part 15 B.
