LAZBOY 1HR Series, Руководство по эксплуатации

Страница: 8 / 25

8
Preliminary
1. Once the furniture is unpacked, carefully remove the red electrical components bag from the body bracket and
set aside; depending on the product purchased, inside the bag are the power supply, power cord, optional
remote and AAA batteries for the optional remote
(F
igure
1).
2. Make back electrical connections.
• Lay the back across the arms of the chair. Turn the locking levers, located on the brackets
attached to the back (one on each side), to a 90° angle (F
igures
2
and
3 ).
• Locate and identify the two electrical connections between the back and the body.
- The blue connectors on the left side (sitting) are for the adjustable headrest feature. One
connector routes from bottom of the back panel and the other between the rear seat and tailgate.
- The gray connectors on the right side (sitting) are for the adjustable lumbar feature. One connector routes
from bottom of the back panel and the other between the rear seat and tailgate.
• Carefully rotate the back until the headrest and lumbar actuator cables are able to reach the
connectors.
• Connect the adjustable headrest (F
igure
4). Align the pins and sockets in the blue connectors,
push the connectors together and close the locking cover to secure the connection.
• Connect the adjustable lumbar (F
igure
4). Align the pins and sockets in the gray connectors, push
the connectors together and close the locking cover to secure the connection.
3. Install the back.
• Continue rotating the back at a slight angle, making sure the headrest and lumbar connections fall between
the rear seat and tailgate, and align the brackets on the back with the brackets on the body (F
igure
2)
• Lower the back onto the body, making sure the back and body brackets are completely engaged.
- To make sure the back is properly installed with both sets of back and body brackets engaged, stand behind the
chair and twist the back from side to side. If one or both sides move out of position the brackets are not engaged
(F
igure
5). Remove the back and repeat the steps above.
- If you are unable to install the back properly, contact your La-Z-Boy
®
dealer for assistance.
• Lock the brackets by using a screwdriver to push down the locking levers (F
igure
3).
4. Locate the motor connector behind the unit. Connect the motor connector to the power supply connector. Align
the connectors, push together until fully seated and close the locking cover to secure the connection (F
igure
6).
5. Remove the power supply box from the electrical components bag. Remove the power supply and 120 volt
power cord from the box.
6. Connect the 120 volt power cord to the power supply (F
igure
6). Do not plug in until instructed in the operating
instructions.
7. Proceed to the Battery Backup Assembly Instructions .
8. To remove the back, unplug the 120 volt power cord from the electrical outlet, and disconnect the power supply
from the motor connector behind the unit. Reverse the Assembly Instructions steps. When lifting the back
up from the body, to lay across the arms,
make sure
to do so slowly and carefully to prevent damage to the
electrical connections.
Assembly Instructions

WARNING
–
To reduce the risk of injury:

Do not operate the unit until the back is installed and locked.

The back of the unit must be lifted for assembly. Please seek assistance if you are unable
to lift at least 45 pounds without strain.
NOTICE
–
To reduce the risk of product damage:

D
o not plug in until instructed.
N18
W29
W88
SUB 3
SUB 4