LAZBOY 1HR Series, Руководство по эксплуатации

Страница: 13 / 25

13
Preliminary
To Program and Use the Memory I or Memory II:
1. Adjust the furniture to the best and most comfortable position for you using the toggle keys.
2. Press and hold the Memory I or Memory II button for three (or more) seconds.
3. Listen for the “beep” to indicate the setting was saved in memory.
• Memory I setting plays a single beep to indicate a successful save.
• Memory II setting plays a double beep to indicate a successful save.
• Three quick beeps play when the setting did not successfully save.
4. The next time you use your furniture, press and release either the Memory I or Memory II button (not holding
longer than two seconds) and the furniture automatically moves to the saved setting. If no setting is stored,
the furniture moves to its home, upright, closed and stored position instead.
Pressing a toggle or button on the control panel will stop the automatic motion of the furniture. The furniture
does not restart once the toggle or button is released. Another press of the Memory I or Memory II button is
required to start the furniture in motion again.
NOTE: All features start in motion upon a Memory button press if the feature is programmed to recline or
extend, except for the headrest.* When the headrest is programmed to extend, the headrest does not start in
motion until the back reaches approximately 40% recline, or its programmed recline setting if set to less than
40% recline. This is done to guard against an undesirable positioning of the head and neck when moving into
the stored recline setting.
* Furniture must be plugged into a power outlet for the Memory feature to function. This feature is disabled
when powered by the 9-volt battery backup. Additionally, when powered by the
optional rechargeable
lithium-ion battery pack, only two features operate at the same time.
To Use the Home Button:
The Home button returns the back is to its fully upright position and the legrest, headrest and lumbar to the fully
retracted and closed position.
1. Press and release the Home button. The furniture automatically starts in motion, moving the back, legrest,
headrest and lumbar back to the upright and retracted positions under full, normal power.
All motion stops if any toggle or button is pressed while the furniture is moving to home. The motion does not
resume when the toggle or button is released. Another press and release of the Home button is required to
restart the automatic home program.
NOTE: When the furniture is powered by the 9-volt battery back-up, the back and legrest move to the home
position first. Once the back and legrest are fully upright and retracted, then the headrest and lumbar begin to
move to the retracted, home position.
When powered by the optional rechargeable lithium-ion battery pack,
the headrest and lumbar return to the Home position first, and then the back and legrest return to Home.
To Use the USB Charging Port:
Plug the USB cable of a small portable electronic device into the USB charging port. Unplug the USB cable from the
charging port when charging is complete.
The USB port is for charging only and does not save or transfer data.
NOTE: When the furniture is operating on the 9-volt battery back-up in the power supply, the USB charge port is
disabled.
Operating Instructions
For Standard Control Panel