LAWO V_pro8, Руководство по установке и эксплуатации, Страница: 25 / 109

V_pro8 Manual V1.0/2 25
Installation & Configuration
TCP/IP Configuration
TCP/IP Configuration
To establish network communication, you will need to configure the TCP/IP settings of your
computer’s Network Interface card and each
pro8 unit.
pro8 TCP/IP Settings
The default settings, as shipped from the factory, are:
LAN 1 IP address = 192.168.123.73
LAN 2 IP address = 192.168.123.74
LAN 1 & 2 Subnet Mask = 255.255.255.0
To reset a device to these settings, use the DEF IP switch on the front panel.
Once you have established a connection, an IP Address can be changed from the Settings
-> Network menu.
Direct Connection
If your computer is connected directly to the pro8 , then configure your computer’s Network Interface
card as follows:
IP Address - in the same range as that of the pro8 LAN port.
For example, if the pro8 IP Address is 192.168.123.73, then set your computer IP Address to
192.168.123.100.
Subnet Mask - identical to that of the pro8 LAN port (default Subnet Mask = 255.255.255.0).
The screenshots on the next page demonstrate this procedure.
Connection via a Network Switch or Hub
In a networked installation, it is likely that you will be connecting multiple devices and/or computers.
Each device on the network requires a unique IP address which may be assigned either statically
(Static IP) or dynamically (via DHCP). Please consult your network administrator for details.
In Version 1.0, the pro8 supports Static IP addresses but not DHCP.
Therefore, you will need to manually configure the TCP/IP settings on each unit. To do this,
connect your computer directly, open a web browser session and use the
Settings ->
Network menu to adjust the IP Address of LAN 1 and/or LAN 2 .