LawnMaster NPTGCP2517B, Руководство оператора

Страница: 29 / 85

29
MAINTENANCE
■ Hook the folded end of the cutting line onto either of the slots in the spool (Fig. 34).
■ Wind the line onto the spool. Wind the line in the “Wind Cord” arrow direction indicated on the spool
(Fig. 34).
■ Place the ends of the line in the two opposite parking slots of the spool, leaving some of the line out
(Fig. 35).
NOTE: Always clean the main spool cover and trimmer head housing before reassembling the trimmer
head.
NOTE: Always clean the trimmer head before replacing the spool.
■ Check the spool cover, spool and spool head for wear and replace parts if necessary. Install the
spool in the spool cover and replace as described in the Spool Replacement section.
NOTE: Only use the appropriate cutting line specified in this manual.
TRIMMER HEAD REPLACEMENT (See Fig. 36-37)
■ Stop the engine and remove the battery pack.
■ Place the trimmer on a flat stable surface with the trimmer head facing upward.
■ Remove the spool head and the main spool cover as described in the Spool replacement section.
■ To install the new trimmer head as shown in Fig. 36, firstly install the main spool cover with the
spool and spring inside; then hold the whole main spool cover and rotate the spool head clockwise
to secure it (Fig. 37).
Fig. 34 Fig. 35
Trimmer
Head
Fig. 36 Fig. 37
Winding
Direction