9
6.5.1 BALANCE UNIT
1. Put on the Brush Cutter strap and attach the
unit to the strap.
2. Slide clamp up or down until the unit balances
by slightly touching the ground.
Set up (LRT-EX
only)
6.5 INSTALLING CUTTING HEAD
1. While locking the gear shaft, by inserting the
supplied tool into the upper holder on the
gearbox, loosen and remove the hexagon nut
(left-handed).
2. Then screw in the cutting head to the gear
shaft over the holders. Hand-tighten it securely.
6.6 ATTACHING THE TRIMMING
MECHANISM
(1) Main pipe
(2) Trimming mechanism
(3) Screw hole
(4) Screw
(5) Fastening bolt
1. Remove the screw that is screwed into the end
of the trimming mechanism.
2. Insert the end of the trimming mechanism into
the main pipe.
3. Line up the hole on the end of the trimming
mechanism to the screw to be inserted with the
hole on the main pipe - screw it in firmly.
4. Using a wrench, screw in the bolt provided to fix
the trimming mechanism into place.
6.6.1 BALANCE UNIT
1. Put on the Brush Cutter strap and attach the
unit to the strap.
2. Depending on the working posture, slide clamp
up or down until the unit balances and the
straps comfortably to your body.
Set up (PS-EX only)
6.7 ATTACHING THE PRUNING
MECHANISM
(1) Main pipe
(2) Gear case
(3) Screw hole
(4) Fastening bolt
(5) Bolt
1. Remove the cap on the end of the main pipe.
2. Remove the screw that is screwed into the end
of the gear case.
