8
2.
Never transport the product over rough roads
or over long distances by vehicle without re-
moving all fuel from the fuel tank. In doing so,
might result in fuel leaks from the tank during
transport.
6. SET-UP
6.1 MOUNTING ENGINE
1. Push the drive shaft housing towards the clutch
housing and rotate it by hand to check that the
drive shaft is engaged with the gears.
2. Insert the drive shaft housing into the clutch
housing until it bottoms, and aligns the
positioning holes on the clutch housing and the
shaft tube and install the screw. When difficult
to engage, twist the engine slightly.
3. Fasten the clamp securely with two screws.
Tighten the screws gradually by turns.
IMPORTANT
Connecting switch wires, connect the switch wires
between the engine and the main. Pair the wires of
the same colour.
6.2 INSTALLING HANDLE (BC-EX, LRT-EX)
•
Install the handle to the shaft tube and clamp at the
location that is comfortable to you. (PS-EX only)
• Insert the grip to the shaft tube.
• F
asten the clamps with screws.
6.3 JOINT ATTACHMENT
• Insert the attachment to the main shaft.
• Tighten the knob bolt securely Set up (BC-EX only)
6.4 INSTALLING DEBRIS GUARD
(1) Screw
(2) Plate
(3) Debris guard
Put the debris guard on the gearbox, attach it with
the 2 screws and hardware provided.
