LawnMaster FD2401, Оригинальное руководство по эксплуатации

Страница: 10 / 16

10
GB
B
C
Emptying the collection bag
notice. All dimensions, references and information
of this instruction manual are therefore without
guarantee. Legal claims, which are made on the
basis of the instruction manual, cannot thus be
considered as valid.
Assembling The Shredder
Unpacking
Make a loop in the power cord
and fasten it to the cable strain
relief . Connect the plug to the
mains socket.
Make sure that the funnel feeder is empty.
1. Set the On/Off switch (10) to “ON” to turn on
the unit.
Place your chopping material in the fill hopper.
The material is drawn in and shredder.
2. Set the On/Off switch (10) back to “OFF” to
turn off the unit.
The shredder will continue to run immediately
after switching off.
the discharge duct!
1. Turn off the unit.
2. Remove and empty the collection bag (4).
Overload protection
n the event of overload, e.g. due to branches
that are too thick, the equipment automatically
switches off.
To restart the unit, wait a little, press the Reset
button (8), then turn on the unit.
Restart prevention
The unit will not automatically restart when the
power returns after a power cut. To restart the
unit, turn on/off switch “on”.
Working methods
General working instructions
Avoid filling the collection bag too much.
Mind that the bag will fill unevenly under
Slide the two wheels (5) onto the chassis axle (6).
Slip the washers (13) onto the axle and stick the
split pins (14) through the appropriate holes in
the axle.
Box contents
• Operating and safety instructions
• Shredder
• Chassis
• Collection bag
• Two wheels, wheel covers, and mounting materials.
• Allen wrench
• Pusher
• Pressure rod
Switching the shredder on and off
If your shredder is fitted with a long mains cable,
plug it directly into the mains supply, using an
RCD device if necessary.
Connect the extension cable.
Slide the axle (6.1) into the chassis (6).
Mount the two wheels (5) onto the chassis (6).
Clip the wheel covers (12) onto the wheels.
Position the shredder (15) on the hopper (1)
(upside down). Push the wheel chassis (6) into
the 2 holes in the plastic housing of shredder.
Secure with the 2 screws provided.
Attach the collection bag
Before each use, always hang the collection bag
over the bag mount (3), keep the collection bag
cover the discharge chute.
Assembling the shredder
Start- up
Check that the mains voltage matches the
rating on the name plate.
Keep your body at a safe enough distance
from the shredder as long branches may
be spun round while being drawn into the
shredder.
Before starting up
，
hook two straps of the collection
bag(4) into the bag mounts(3).(figure A)