3
G. Balanced/Unbalanced Switch
The XLR outputs of the MP10 are electronically balanced and should not be connected to
an unbalanced input without first setting the rear panel switch to “unbal.” Doing so will not
cause damage to the amplifiers, but will raise the distortion level of the outputs
significantly. The switch is located between the two sets of XLR connectors and is
labeled “bal” and “unbal.” The peak output level is reduced from +24 dBu to +18dBu
when the switch is set to “unbal.” After AC power is applied, the setting of this switch is
displayed in the left GAIN display during initialization as “ba” for balanced and “Ub” for
unbalanced.
SPECIFICATIONS:
Distortion
-
Measured at -3dBFS (21dBu) at 1kHz, 10kHz, &20kHz:
Gain Setting 20
Less than 0.00070%dBFS
Gain Setting 40
Less than 0.00090%dBFS
Gain Setting 60
Less than 0.00800%dBFS
Noise
-
Input referenced noise at Gain Setting 40 with -999dBr input
150 Ohm source
Less than -124dBu (Unweighted)
Less than -127dBu (A-Weighted)
Inputs- Transformer-free electronically balanced Pin 2 “+” XLR inputs with common hi/lo
impedance switch.
Phantom Power- +48 volts Phantom power for condenser microphones, can be enabled or
disabled for each input channel individually using front panel switch.
Outputs- Transformer-free electronically balanced outputs. Rear panel switch for balanced Pin 2
“+” or unbalanced Pin 2 “Hot” operation.
Meter- 14 segment LED meter per channel, displays output signals ranging from -42 to 0dB
below peak output level. Maximum balanced peak output 24dBu, maximum unbalanced peak
output is 18dBu.
Dimensions and Weight- 8”wide x 10.75” deep* x 1.75” high, 4.5 lbs
*depth includes clearance for front and rear panel switches and connectors
AC Power:
Voltage 90-264 VAC, Frequency 47-63Hz, Current 0.1A
Fuse Rating 4A “Fast Blow” *
*Subject to change! Please always check the rating on the fuse and the one printed next to the
fuse holder on the power supply PC board before replacement. Replace the fuse ONLY with a
fuse of the same rating. If you have any questions, contact:
ACCESSORIES
Included in box: U.S.A. Power Cord, Warranty Card, This User’s Manual
Optional: LavryBlack Series 19 inch rack-mount kit. This kit is designed to mount two LavryBlack
units side-by-side in a 1U rack space.
Содержание MP10
Страница 2: ......
