GB
5
Before using for the first time Usage
Assemble the appliance
1. Photo sequence D:
• Fit the wheel onto the axle
• Fit the other wheel, ensuring that the pin
fits into the recess in the axle.
• Push the plugs into the wheel centres
until they fit into place (as shown in the
cross-section drawing)
• Fit the tank .
2. Photo sequence E:
Note: Turn the appliance around to face
the rear of the unit for the following sequence
of instructions.
• Securely mount the nozzle holder (a)
(with the Phillips screw and washer) onto
the bottom right hand side of the unit,
fitting it onto the relative lug
• Securely attach the accessory holder
(with the rounded side facing down) at
the rear of the unit
• Fix the accessory support to the cable
winder on the left and to the nozzle
holder on the right (b).
3. Photo sequence F:
• Nozzle cleaning pin fixture
• Securely attach the hose reel support
to the rear of the unit, using 2 Phillips
screws. Ensure that the side with the round
and rectangular openings is installed on
the left hand side
• Completely unwind the hose from the hose
winder before assembling the 2 parts.
• Take the 2 sections of the hose reel
• Fit the 2 sections together and feed the
hose out through the aperture
• Now secure the 2 sections with 4 Phillips
screws
• The high-pressure hose end will be
attached to the gun.
4. Photo sequence G:
• Turn the drum , keeping the hose
connector on the left hand side
• Fit the previously assembled drum
onto the bracket at the rear of the unit.
Press on the drum to secure it into its
mountings on the bracket.
• Fit the hose connector underneath and
screw securely onto the outlet connector
• Fit the crank handle to the right hand
side of the drum with a Phillips screw
• Rewind the hose with the handle, without
tightening excessively.
• Connect the short high-pressure hose
connector to the spray gun quick release
connector. Lift the ring on the spray gun
mount , insert the end of the hose
and release the ring. Check that it
has engaged correctly.
• Secure the handle to the rear of the
unit with 3 Phillips screws.
Usage
Caution: For safety reasons, always use
both hands to assemble the nozzle and
spray gun before starting a job.
Connection to the water mains
Main ON / OFF switch
High-pressure water outlet (OUTLET)
Plug/wall socket
Water tap
Water supply hose
Water inlet (INLET)
Water filter
Mounting
Snap-on hose connector
Detergent tank
High-pressure hose
Spray gun safety catch
Spray gun trigger
• Check that the main switch is “OFF”;
• The water inlet hose must be fitted to
the snap-on hose connector
Caution: use a hose with a minimum
pressure resistance of 15 bar / 200 psi,
and an internal diameter of at least 13
14
10
15
5
12
14
15
13
4
3
26
16
T
9
26
7
7
7
16
17
18
19
20
21
22
23
24
20
25
26
27
28
4
24
11
8
6