GB
4
Safety Before using for the first time
an electrical overload cutout system (CL.
I) and pump bypass valve or stop system.
•
CAUTION: The spray gun is
equipped with a safety catch.
When the appliance is not in use,
always engage the safety catch
to prevent the machine from being started
unintentionally.
• Never direct the jet towards yourself or
any other person to clean clothing or
footwear.
• Never allow children or persons without
the necessary skills to operate the
machine.
• CAUTION: Do not leave the appliance in
standby mode for more than 5 minutes.
• CAUTION: Always switch off the appliance
completely (main switch OFF) whenever
leaving it unattended.
• CAUTION: This machine uses high-
pressure fluids. Always grip the gun
firmly to counteract the recoil. Only use
the high-pressure nozzle supplied with the
machine.
Additional safety information
Water supply
• See chapter “Technical specifications”.
• Only use clean water.
Caution: Failure to observe the above
conditions will cause serious mechanical
damage to the pump and will void the
guarantee.
High-pressure hose
Caution: The high-pressure hose
has been specially designed to resist
high pressures. Treat with particular care
to prevent damaging it.
• Avoid tangling.
• Do not bend the hose or subject it to high
stress or strain
• Never start the high-pressure cleaner
without first completely unwinding the high-
pressure hose .
• Before unwinding or winding the hose,
switch the machine off and release the
pressure in the hose itself (pull spray
gun trigger 2-3 times).
Caution: Inappropriate use may cause
damage or untimely breakage and voids
the guarantee.
Electrical power supply
• Warning: Before connecting the appliance,
ensure that the specifications listed on the
identification plate match those of the mains
electric supply and that the socket is
protected by a differential magneto-thermal
circuit breaker with a trip threshold less
than 0.03A - 30ms.
• If the mains power lead or plug is damaged,
have it repaired or replaced by a customer
service centre.
• Do not use the appliance at temperatures
lower than 0
°
C.
Caution: Non-approved extension leads
may be dangerous and must never be
used.
• If an extension lead is used, both the plug
and the socket must be waterproof and the
cable cross section must be as specified
in the following table.
Before using for the first time
Warning:
• Before assembly, ensure that all
appliances and accessories listed in the
chapter “Equipment” are present
• Each unit is test run after manufacture,
therefore you may find some residual water
in the water intake.
230 - 240V
1,5 mm
2
max 20 m
2,5 mm
2
max 30 m
18
26
26
4
4