LAVOR Pro FOAM BOX, Инструкция пользователя

Страница: 5 / 24

5
INTENDED USE
-
The appliance is intended for professional use.
-
The appliance is intended for use as FOAM
INJECTION.
SYMBOLS
CAUTION! It is important to be careful of the fol-
lowing items.
IMPORTANT
IF PRESENT
Double insulated (IF PRESENT): supplementary
insulation is applied to the basic insulation to pro-
tect against electric shock in the event of failure
of the basic insulation.
TECHNICAL DATA
(see technical data plate)
SAFETY
GENERAL WARNING
Components used in packaging (if plastic bags) can
be dangerous keep away from children and animals.
Operators shall be adequately instructed on the use
of these machines.
The use of this machine for anything not specified in
this manual may be dangerous and must be avoided.
Always check the appliance before use.
The appliance is not to be used by children or per-
sons with reduced physical, sensory or mental capa-
bilities, or lack of experience and knowledge, unless
they have been given supervision or instruction.
Children being supervised not to play with the ap-
pliance.
The equipment should be correctly assembled before
use.
Ensure that power sockets used are correct for the
machine
Never grasp the mains plug with wet hands.
Check the voltage indicated on the rating plate is
the same as the supply voltage.
Never leave the equipment unattended whilst in use.
Never carry out any maintenance on the machine
without first disconnecting from the mains supply or
when it is left unattended or reachable by children or
disables.
The mains supply cable should not be used to pull or
lift the machine.
The machine should never be immersed and never
use the water jet against the appliance to clean it.
When using the machine in wet rooms (e.g. in the
bathroom) only connect it to sockets which are
connected in series with a ground fault circuit in-
terrupter. In case of doubt, consult an electrician.
Periodically examine the power cord and machi-
ne for damage. If any damage is found, do not use
the appliance but contact your service centre for
repair.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similary
qualified persons in order to avoid a hazard.
Should extension cables be used, ensure that these
lay on dry surfaces and protected against water jets.
The equipment should not be used to pick up wa-
ter from containers lavatories, tubs, etc.
Aggressive solvents or detergents should not be
used.
Service and repairs must be carried out by qualified
personnel only. Only use manufacturer original spare
parts for service repair.
The manufacturer cannot be held responsible for any
damage/injury caused to persons, animals or proper-
ty caused by misuse of the appliance, not in complian-
ce with manual instructions.
32Foam function: connect the device to a 6 bar
minimum air compressor (not supplied).
33Foam function: Using specific detergents is in-
dispensable for foam production.
34Always test on a hidden area of the material.
DESCRIPTION AND ASSEMBLY ISTRUCTIONS
①
Compressed air fitting
②
Compressed air pressure gauge
③
Compressed air knob regulator
④
ON /OFF switch for detergent/foam pump
⑤
Power cable
⑥
Outlet fitting
⑦
Hose
⑧
Lever
⑨
Foaming lance
⑩
Detergent tank
⑪⑫
Detergent hoses