lavina V32E, Руководство пользователя

Страница: 22 / 57

Superabrasive Owner’s manual original language – Lavina
®
V32E 01/2020
22
1. Place the LONGOPAC® bag refill into the support ring. Ensure that the 2 ends of the refill are
directed in an upwards position. Pull the inner end of bag refill down over the inside surface
of the bag support ring by making sure that the hook of the holder sticks out from the bag
(Fig 7.7.1 and 7.7.2).
2. After you install the new bag, you need to attach the holder back to the filter chamber by
following the steps form fig. 7.7, performing it backwards.
3. After you attach it and the zip tie has been securely installed, pull the bag down until the end
reaches the lower, bag-support plate (fig. 7.6.2). The vacuum cleaner is now ready for
operation.
8. MAINTENANCE AND INSPECTION
ATTENTION!
Wait until turbine impeller has completely stopped before starting servicing the machine.


Before moving the dust collector from the working area, the machine must be
cleaned.

All other equipment must be considered to be contaminated and be treated
thereafter.

If possible, use a special suitable room.

Proper personnel protective equipment must be used.

After a service, all parts that are contaminated must be taken care of properly in
plastic bags, according to
all regulations.

If the dust collector has to be used for other purposes, it is extremely important that
the machine is
cleaned to avoid the spread of hazardous dust.
In order to ensure safe and efficient operation of the dust collector, the following procedures should
be performed periodically (depending on the frequency of operation):

Remove and inspect the filters for any signs of excessive wear or damage. Replace as
necessary. (See section on “Filter Removal”).

Ensure that the gaskets on the filters are free of excessive wear or damage. Replace as
necessary.

Inspect all electrical components (switches, plugs, cables, etc.) for damage or exposed wiring.
Replace as necessary.

Ensure that all screws, bolts, and nuts are properly tightened.

Check the waste container level. Always clean and change the bag when the debris reaches a
maximum of 75% of its full capacity.

Check the flexible vacuum hose and accessories for significant wear or damage. If holes are
present, the dust collector’s efficiency will be reduced, and debris will leak into the work
environment. IMPORTANT: All major repair work should be performed by Superabrasive or
an authorized repair facility.
CHECK DAILY: After operating the
V32E
, the operator should conduct a visual inspection of the
machine. Any defect should be solved immediately. Pay attention to plugs and vacuum hoses, loose
bolt or screws.