lavina V20GE, Руководство пользователя

Страница: 24 / 47

Superabrasive Owner’s manual original language – Lavina
®
V20GE 01/2020
24
1. Place the LONGOPAC® bag refill into the support ring. Ensure that the 2 ends of the refill are
directed in an upwards position. Pull the inner end of bag refill down over the inside surface
of the bag support ring by making sure that the hook of the holder sticks out from the bag
(Fig 7.6.1 and 7.6.2).
2. After you install the new bag, you need to attach the holder back to the filter chamber by
following the steps form fig. 7.6, performing it backwards.
3. After you attach it and the zip tie has been securely installed, pull the bag down until the end
reaches the lower, bag-support plate (fig. 7.5.2). The vacuum cleaner is now ready for
operation.
8. MAINTENANCE AND INSPECTION
Tampering w/emission control system prohibited.
Federal law and California State law prohibits the following acts or the causing thereof:
1. The removal or rendering inoperative by any person other than for purposes of
maintenance, repair, or replacement, of any device or element at design incorporated
into any new engine for the purpose of emission control prior to its sale or delivery to the
ultimate purchaser or while it is in use.
2. The use of the engine after such device or element of design has been removed or
rendered inoperative by any person.
Among those acts presumed to constitute tampering, involve the parts/systems listed below:
- Carburetor and internal parts ;
- Spark plugs ;
-
Magneto or electronic ignition system;
-
Fuel filter element;
- Air cleaner elements;
- Crankcase;
-
Cylinder heads;
- Breather chamber and internal parts;
- Intake pipe and tube;
WARNING!
Before cleaning and servicing the machine, you must turn the machine off and disconnect battery
and propane tank.
ATTENTION!
- Wait until turbine impeller has completely stopped before starting servicing the machine.
- The exhaust will get very hot after running the engine for just a short time.
- Before moving the dust collector from the working area, the machine must be cleaned.
- All other equipment must be considered to be contaminated and be treated thereafter.
-
If possible, use a special suitable room.
-
Proper personnel protective equipment must be used.