Laversab 6300-M3 Rev C3, Руководство пользователя

Страница: 65 / 72

58
SECTION 8
COMMUNICATION INTERFACE
The model 6300-M3 is capable of communicating with a remotely located computer via the
RS232 serial interface. Using this interface it is possible to perform all functions that are
available on the front panel.
8.1 RS232 SERIAL INTERFACE
The serial interface is a three wire interface using the signals RX, TX and GND. Each byte of
data is sent in ASCII format using 8 bits per byte, with 1 stop bit, no parity at 9600 baud.
The pin-out of the interface is as follows:
Pin 2 - Transmit (TX)
Pin 3 - Receive (RX)
Pin 5 - Signal ground (GND)
The baud rate, parity, bits per byte, and number of stop bits cannot be altered and is set to
9600, No parity, 8 bits and 1 stop bit respectively.
8.2 IEEE-488 INTERFACE
This interface is accessible through the 24-pin parallel connector under the “Interface
Connectors” cover on the top panel. This interface supports the following IEEE-488 functions.
SH1 Source Handshake
AH1 Acceptor Handshake
T2 Basic Talker
L2 Basic Listener
SR1 Service Request
DC1 Device Clear
The IEEE-488 address of the 6300-M3 can be changed using Function ‘0’ as described in
Section 3.5.0.