Technical support maintenance manual
Rel. 0.00 / June 2018
6
6. INSTALLATION, COMMISSIONING AND
CONFIGURATION
6.1. UNPACKING
Open the package taking care not to damage it.
Extract the machine, pulling it out of the protective casing.
Environment
The components making up the packaging must
be separated based on the nature of the materials
and disposed of in compliance with laws in force
regarding separate waste collection and disposal.
6.2. POSITIONING
For correct ergonomic use, it is recommended to install
the machine on a flat, horizontal and stable surface,
away from water, flames and sources of heat. The cho
-
sen area must be sufficiently lit, ventilated, hygienic,
non-corrosive and/or non-explosive.
Furthermore, the socket must be easily reached by the
power cable.
The following recommendations apply for the appliance
to work properly:
- minimum and maximum room temperature: 5° C ÷ 40° C;
- maximum humidity: 75 %.
Note
For operations regarding positioning of the ma-
chine, see the indications provided in the Installa-
tion Manual supplied with the machine.
Warning
The machine is not fit to be installed outdoors ex-
posed to atmospheric agents. The presence of
magnetic fields or adjacent electric machines that
generate interference could cause the electronic
controller of the appliance to malfunction.
Warning
Temperatures near 0 °C could cause freezing and
damage internal components containing water.
Attention
There must be free access to the machine and to
the plug to allow the user to intervene without any
constraint and to be able to immediately leave the
area if necessary.
6.3. START-UP PROCEDURES
To start the machine:
- remove the water tank, rinse and fill it using only fresh
non-carbonated drinking water;
- reposition the tank, with the cover;
- plug in the machine;
- press one of the two buttons on / dispensing to switch
on the machine.
The warm up cycle begins: the on / dispensing buttons
begin to flash white.
When the two dispensing buttons are steadily lit white,
the machine is ready for use.
Warning
The amount of water in the tank must never exceed
the maximum level (MAX).
Note
At first start-up, or if there is no water, the machine
will fill the water circuit by enabling the pump for
a brief moment. At first start-up, dispense at least
0.5 litres of water with no capsule. Upon the first
start-up, dispense at least 0.5 litres of water with no
capsule.
Note
For operating procedures and functioning logic of
the machine, follow the instructions provided in the
Installation Manual supplied with the machine.
7. PROGRAMMING
7.1. DOSES
The machine allows the desired amount of dispensed
product to be set.
Adjust the dose as follows:
- insert a capsule in the relevant compartment;
- close the capsule loading lever;
- press and hold in the dispensing button to be pro-
grammed for at least 3 seconds;
[dispensing begins and the selected button flashes]
- release the button only when the desired quantity of
product has been reached.
