19
END display flashes 1x.
(Problems with water
inflow)
Tap turned off.
Turn tap on.
Filter in the screw connec-
tion of the inlet hose is
blocked.
Turn off the water tap. Un-
screw hose, take out filter
and clean it.
Water tap is blocked with
limescale or faulty.
Check the water tap and
have it repaired if necessary.
The washing machine
vibrates when operating
or is not stable.
The transit packaging has
not been removed.
Removing the transit pack-
aging.
The screw feet not correctly
adjusted.
Adjust the feet as described
in the installation and con-
nection instructions.
Washing has not been
spun.
Only a few large items of
washing in the drum.
Always load the drum as full
as possible. Mix large and
small items.
Water is leaking out un-
derneath the washing
machine.
Screw connection on the in-
let hose is leaking.
Tighten inlet hose.
Drain hose is leaking.
Replace drain hose.
Drain pump cover is not
closed properly.
Close cover properly.
Washing was caught in the
door.
Load washing carefully for
the next wash.
Emergency drain hose is
leaking.
Close off emergency drain
hose properly.
Washing water is foam-
ing excessively.
Probably too much deter-
gent has been used.
Dose detergent exactly as in-
structed by manufacturer.
END display flashes 2x.
(Problems with water
outflow.)
Kink in drain hose.
Remove kink.
Maximum pumping height
of 1m exceeded.
Please contact Customer
Care Department.
Drain pump is blocked.
Switch off appliance. Pull out
mains plug.
Clean drain pump. Remove
foreign bodies from pump
housing.
With connection to sink
outlet: sink outlet is
blocked.
Clean sink outlet.
Fabric softener not
rinsed in,
w
compart-
ment for additives is
filled with water.
Conditioner insert in the
compartment for additives
is not correctly attached or
is blocked.
Clean detergent dispenser
drawer, insert conditioner in-
sert firmly.
Problem
Possible cause
Remedy
