LAUREL MAGNA, Инструкция по установке и эксплуатации

Страница: 21 / 37

21
Set1 Set2 Output Alarms
Digit OK
Max/Min Reset
Set1 Set2 Output Alarms
Digit
OK
Max/Min Reset
Press to accept
1
2
Press to accept
Set1 Set2 Output Alarms
Digit
OK
Max/Min Reset
Display now shows briefly. You
can now specify the low reading. Use
DIGIT to select each digit in turn, and the
UP or DOWN arrow to increase or de-
crease each digit’s value, as required.
Eg., set
(4 digits) for 0 to 100.0 or
0 to 100.000
Theoretical Calibration - Low End Calibration
This is when you type in the sensor’s theoretical signal level at the top and bottom of
its range and the value to display, for each signal level.
If you have not done so before, please select Theoretical Calibration mode
from the
Meter Calibration page.
Done!
You can set Zero first, if you prefer, but you will not be able to change the decimal
point position in the ZERO calibration step. This will not be an issue if your zero
calibration reading is 0, but may become confusing otherwise.
Set1
Set2 Output
Alarms
Digit
OK
Max/Min Reset
Lockout Switch must be OFF
Press 3 seconds
OFF
Circuit board ON
Set1 Set2 Output Alarms
Digit OK
Max/Min Reset
Press OK. You can now specify the lowest input signal. Use DIGIT to select
each digit in turn, and the UP or DOWN arrow to increase or decrease
each digit’s value, as required. Eg., set
(4 digits) if your input is 4-20
mA.
Display shows (4 digits) followed by
or
, depending on whether you
have chosen current or voltage input, then
3
4
5