Launch VALUE-601A, Инструкция по использованию, Страница: 15 / 33

WORKING CYCLE
Select the AUTOMATIC CYCLE / MANUAL
PARAMETER SETTING mode (drawing at the
right) and reach the following menu
NOTE: by choosing START and pressing on
ENTER; the unit performs all the cycles with
the shown parameters.
To perform the single phases, choose the
working phase, press
ENTER and change
parameters (if any) by means of the
buttons
UP/DOWN
RECOVERY : immediate start of the gas
recovery from the vehicle only (recovery
followed by the oil drain). Press
ENTER to
start the recovery cycle only.
NOTE : After the recovery of the refrige-
rant, the unit displays the oil drain phase.
Always allow the oil drain phase to
finish
VACUUM: press ENTER to change the
vacuum settings.
Change the settings by means of the buttons
UP/DOWN. Presss ENTER to start the cycle
15
www.diagtools.eu, diagtools@diagtools.lv, Pernavas 43A, Riga, Latvia, LV-1009, +37129416069