![background image](http://html1.mh-extra.com/html/launch/value-601a/value-601a_use-and-instruction-manual_3915341014.webp)
WORKING
CYCLE
EXIT to finish the cycle. Follow the instructions
on screen and close/disconnect hoses to reco-
ver the gas residuals.
ENTER to confirm The unit recovers any gas
residuals left in hoses before ending the
procedure.
Alternatively, if the hoses length has been
set at “0” (see SETTINGS instructions), reco-
vers the residuals in the A/C system. In this
case CLOSE HP quick coupling only (LP open)
Even after the recovery into the A/C system,
there will be still small quantities of vapors left
in the hose to be recovered.
Press ENTER and wait until the unit ends the
recovery from the hoses and shows the
operation report page.
At the very end of the cycle, ENTER to print
the result
Press EXIT to return to the main menu
B)
To perform each single working phases in MANUAL mode (manual setting of the working parameters):
14
www.diagtools.eu, [email protected], Pernavas 43A, Riga, Latvia, LV-1009, +37129416069