LAUNCH
Tyre Changer(TWC Series)
7
Fig.16
l
Depress the pedal
“
“
to turn the turntable while
keeping pressing on the tyre. When only 10
—
15cm
is left, slow down to avoid damage of the tyre bead.
Stop the motor if there is any indication for damage.
Lift the pedal
“
”
by foot
to turn the turntable
counter-clockwise. Try again after making the tyre
back to the original shape.
Attention:
u
If the rim size does not change, it is not
necessary to loose the locking handle
after finishing the mount and demount of
the tyre and adjust the mount/demount
head before mount and demount of tyre.
The operation will be continued by
depressing the column tilting control
pedal to make the titling column let go
and restore automatically.
u
Make sure nobody is behind the tilting
post when depressing pedal (G).
u
In the process of clamping, keep head
and hands away from the area between
the tyre and the horizontal arm in case
injury would be incurred.
Inflating tyre
Danger!!
Inflating can be highly dangerous. Take precautions
and pay close attention to the procedures. Check
pressure gauge and air circuit are in good condition
before inflating.
The machine is equipped with a gauge to read the
pressure in the tyre.
l
Loose the wheel on the turntable.
l
Connect the outlet of the inflating device to the air
inflation valve as shown in Fig.17.
l
Slowly and repeatedly depress the inflation pedal (to
avoid over-high pressure) to make sure that the
reading
on
pressure
gauge
within
the
manufacturer
’
s requirements. The pressure should
not exceed 3.5 bar. The user may adjust the
reducing valve in the machine to get different
pressures according to requirements.
Quick-inflation:
l
If the tyre is tubeless or the tyre does not match the
rim hermetically, inflation method above-mentioned
will has no effect. In this case, the quick-inflation
should be adopted. The quick-inflation method is to
depress pedal
“ ”
to lock the rim, then depress the
inflation pedal on right-hand of the cabinet to its
end quickly and loose the pedal immediately. The
quick-inflation is finished with a rat-tat.
Attention:
Make sure that the tyre is clamped tightly, otherwise it
has danger of death.
Warning: Danger of explosion!
The safety procedures should be closely followed.
Review and abide by the following instructions.
Otherwise serious injury or death can be resulted.
The manufacturer shall not be held responsible for
any possible accident when the safety procedures are
not followed.
u
Carefully check the dimensions of rim and
tyre to see if they match each other. Check
and make sure that the tyre is not worn or
damaged before inflation.
u
When a high pressure is required, remove the
tyre from the tyre changer and resume the
inflation in a special protective hood.
u
Be careful when inflating the tyre. Keep
hands and other parts of human body away
from tyre.
Fig.17
