LAUNCH
KWB-511 Wheel Balancer user’s manual
11
40Cr
Left and right were
displayed inside and
outside of the imbalance
value ALU
Rotate the wheel, when it comes
to the inside correction position,
the outside display window
twinkles to show the distance
between the correction position
and the sensor arm tip
Pull the sensor arm and stick
the counterweight on the
exact
”
0" distance position
shown on the outside display
window
Medial end of lead paste
Fig16
Note: The KWB-511 mechanical sensor arm can only locate the 12 o’clock position, it will return to the measurement
interface if at any other position. So it is better to locate it at 12 o’clock and do the following operation.
9. OPT Function
OPT function is used to determine the
best mating of tire and rim
. When doing dynamic and static modes,
if the static
mode value is greater than OPT value (implied 30g), then it’s better to start optimization.
When optimization is asked, press
key to operate according to the following table. When optimization is not needed,
display “OFFOPT” and exit OPT operation.
