8
REAR SHOWER
While you are sitting on the shower toilet, briefly press the controller on the right side to start the rear
shower. If you need to stop the shower prematurely, press the controller again.
If you wish to shower again, press the controller while the shower arm is retracting at the end of the first
showering procedure.
The factory setting for the heating is always “switched on” (see section 4.2.3).
If you shower repeatedly, the water will gradually become cooler.
The shower duration is factory preset to 25 seconds.
Improper operation includes initiating the shower procedure without anyone sitting on the shower toilet.
This may cause water damage in the surrounding area.
JET INTENSITY
The jet intensity can be adjusted to one of 7 settings. You can adjust the jet intensity while showering by
turning the controller.
Turn the controller forwards to increase
the jet intensity.
4.1
4.1.1
4.1.2
4 OPERATING THE SHOWER TOILET
Turn the controller backwards to reduce
the jet intensity.
The jet intensity is factory preset to 4 out of a possible 7.
SHOWER JET POSITION
The position of the shower jet can be adjusted to one of 7 settings. While showering,
you can simultaneously press and turn the controller back or forwards.
The shower jet follows the direction of rotation.
Press the controller and simultaneously
turn it forwards to move the shower jet
forwards.
Press the controller and simultaneously
turn it back to move the shower jet back.
The jet position is factory preset to 4 out of a possible 7.
OSCILLATION
Press the controller and turn it quickly forwards and backwards twice to generate an automatic forwards
and backwards movement of the shower jet.
4.1.3
Laufen_Cleanet_Navia_manual_EN.indd 8
Laufen_Cleanet_Navia_manual_EN.indd 8
29.10.21 09:45
29.10.21 09:45
