Step By Step Instructions
Anchor the non-motor side of the mechanism
into the cover box in as many places as
possible. Use the appropriate screws and
anchors depending on the type of cover box
being used.
With the brackets on the non-motor end in
position, place a small level across the
brackets to make sure they are level with
the bottom of the track. Tighten the nylock
nuts on the adjustable brackets.
With the brackets in position, place a small
level across them to make sure they are level.
Tighten the four nuts on the adjustable
motor end brackets.
12
18
Loosen the bolts on the adjustable brackets
on the non-motor end of the mechanism.
Spread the pulley brackets outward against
the walls of the cover box.
Anchoring
t
he Pulley Brackets
Anchor the motor mechanism brackets into
the cover box in as many places as possible.
Use the appropriate screws and anchors
depending on the type of cover box being
used.
On the motor and non-motor side, use the
half inch screws (37) and nylock nuts (47)
provided and secure the cross braces
together.
10
11
13
14
15
Attach the #8 copper bond wire that is
stubbed into the cover box to the
bonding lug on the motor end of the
mechanism.
Make the same connection with the #8
copper bond wire that is in the cover box
on the non-motor end of the mechanism.
16
17
© Latham Pool Products, Inc. 2018. All rights reserved.
Numbers in parenthesis refer to hardware shown on page 3.
11 of 19
