Routing the Ropes
Begin on the motor end of the
mechanism.
Run the rope from the track so it travels
straight from the track to the first pulley.
Extend the rope out the back side of the
pulley.
On the non-motor end, feed the rope
around the pulley of the non-motor end
pulley bracket. Pull the rope through to the
motor end.
Feed the non-motor end rope behind the first
and second and third horizontal pulleys.
Pull the rope around the vertical pulley on the
front wall of the cover box.
On the motor end, feed the rope around
the first and second horizontal pulleys on
the back wall of the cover box.
Pulll the rope around the vertical pulley on
the front wall of the cover box.
10
11
12
13
14
15
Run the rope from the non-motor end
along the backside of the cover box. The
rope should run through the rope loops
(39) to keep it from getting caught in the
cover. Space the rope loops evenly across
the back of the cover box.
16
The cover must be open when cutting
and
attaching the ropes.
Pull the cover back
until the sliders are against the guides. Pull
the ropes tight as they come off the pulleys
on the mechanism to eliminate the slack in
the rope.
While pulling both ropes tight, use a lighter
or torch to burn the rope in the location it
will be cut. This will help them not fray after
they have been cut. Cut the ropes so they
are at least 8 ft long. Use the lighter to
reburn the cut ends of the rope if needed.
17
18
© Latham Pool Products, Inc. 2018. All rights reserved.
Numbers in parenthesis refer to hardware shown on page 3.
Step By Step Instructions
15 of 19