Bring the ropes back to the mechanism. Slide
the rope through the rope lug on the rope
reel. Secure the ropes to the reel by
tightening down the set screws in each lug.
While holding the ropes over the
mechanism, run the key switch in the
cover position. The excess rope will be
wrapped around the rope reel.
Running Out
t
he Cover
Run the cover over the pool being careful to
prevent it from binding in the guide feeds by
lifting the cover if necessary.
Attaching
t
he Cover & Bonding
Wire
Make sure the webbing continues
straight as it travels from the track to the roll-
up tube. Attach the cover to the roll-up tube
using tek screws (32). The first screw on each
end of the tube needs to be 3 inches from the
end of the tube. As the cover rolls up on the
tube, the webbing should roll up completely off
the tube.
Lay the bond wire on top of the cover fabric.
Secure it to the roll-up tube using a tek screw
(32). Distribute the slack of the cover evenly
between each screw across the length of the
tube. Secure the cover to the roll-up tube
using tek screws (32) every 2-3 feet. When
attaching the cover to the tube,
do not use
folds or pleats
.
Run the key switch in the uncover position to
roll the cover up on the roll-up tube. Check
the cover to be sure it rolls up evenly. Run
the cover 6-10 times to make sure it opens
and closes evenly. The cover fabric installation
is now complete.
28
29
30
31
32
33
38
39
40
Adjusting the Ropes
When closing the cover, if both sides of the
cover don’t close squarely, one of the ropes
may need to be adjusted. To adjust the rope,
open the cover all the way. Pull the excess
rope off the rope reel.
If one of the ropes is longer than the other
rope, loosen the set screw that secures the
rope to the rope reel lug. Shorten this rope
until it is the same length as the other rope.
Re-attach the rope to the rope reel.
If both ropes are the same length, and the
cover doesn’t close squarely, shorten the rope
for the side of the cover that doesn’t close all
the way. The amount that the rope is
shortened is equal to the amount distance
that the cover needed to travel to close all the
way. While holding the rope, run the switch in
the cover position.
34
35
36
© Latham Pool Products, Inc. 2018. All rights reserved.
© Latham Pool Products, Inc. 201
9
. All rights reserved.
Step By Step Instructions
Numbers in parenthesis refer to hardware shown on page 3.
14
