Lassco Spinnit FMM-2, Руководство пользователя

Страница: 9 / 25

4 - Operation
Page 08
4.2.3
4.2.4
4.2.5
Diagram 4-30
To install a drill bit, grasp the drill bit and being
careful to keep it straight, press it up into the Chuck.
Seat the drill bit by using a stack of scrap paper. Set the scrap
on the table as shown. Step on the foot pedal slowly raising the
table toward the drill bit. Put light pressure on the hollow drill bit
seating it firmly in place.
Remove the scrap paper and turn the machine on to check the
concentricity of the bit. If the bit is not concentric, remove it and
repeat steps 4.2.1 through 4.2.4 until it is concentric.
Chip Chute
Chuck
Hole Guard
Drill Bit
4.1 - Protective Guard
4.2.1
4.2.2
Remove the hole guard which is attached to the chuck. This is
done by grasping the tab and sliding the guard off.
Using the Chuck Release Key (EBM-32), insert the tapered end
facing down into the chuck hole. With a clockwise motion turn the
Chuck Release Key 45 degrees. The drill bit will slide out of the
spindle. It is recommended that you hold onto the drill bit so that
it does not drop out of the spindle damaging the tip. Place the
hole guard back onto the chuck to protect debris from clogging
the spindle.
Diagram 4-20
Chip Chute
Chuck
Hole Guard
Drill Bit
Chuck Release Key
Tab
CAUTION: DRILL BITS MAY BE HOT AFTER USE. ALLOW DRILL BITS TO COOL
DOWN BEFORE TOUCHING.
BEFORE REMOVING OR INSTALLING THE DRILL BITS, DISCONNECT OR
LOCK-OUT THE POWER SUPPLY.
4.2 - Drill Bit Removal and Installation
Diagram 4-10
4.1.1
4.1.2
Your FMM-2 comes with a protective guard installed. DO NOT
operate this machine without the guard in place.
Please note that when you are performing certain operations such
as removing and installing drill bits, you will need to move the
guard out of the way. Making sure the power to the machine is
disconnected or locked-out, push the guard up and hold in place
while performing necessary operations or maintenance. The pro-
tective guard should not be removed during operation.