6 - Trouble Shooting Guide
6.1 - Determining the Cause and Correction to Certain Problems
Page 19
Problem
Cause
Correction
Uncommon metallic sounds
from under the shroud.
The Drive Pulley is loose.
Adjust the Drive Pulley to the
proper height and tighten or
replace the Set Screw.
The Chuck cannot be
adjusted according to the
Operating Instructions
.
The Chuck has been adjusted
too far down causing the adjust-
ment threads to be disengaged.
Re-adjust to a lower position
which may require you to use
new hollow drill bits.
The Chuck has been rotated
while in the down position.
Push up on the Chuck and rotate
slowly while holding the Spindle
stationary until the Chuck returns
into a locked position.
The Needle Bearings on the Idler
Pulley(s) are not lubricated.
Lubricate the Needle Bearings as
needed.
The Chuck adjustment is designed for a 1/4” total move-
ment up and down. Once you have sharpened the drill bit
down more than a 1/4” from its original length you must
replace it. Any drill bits that are longer than approx 2-1/4”
or shorter than approx 2” may cause Chuck adjustment
problems.
Note:
Содержание Spinnit FMM-2
Страница 21: ...7 Parts Diagrams 7 1 Side View Page 20 ...
Страница 22: ...7 Parts Diagrams 7 2 Head Assembly Page 21 ...
Страница 23: ...7 Parts Diagrams 7 3 Spindle and Chuck Assembly Page 22 ...
Страница 24: ...7 Parts Diagrams 7 4 Rear View Page 23 ...
