Manual / Bedienungsanleitung: RS 800 G, RS 800 RGY, RS 1000 RGB
Page / Seite 7 von / of 17
Revision Sep-10
170~255
Large to small
11
Drawing speed
0~255
slow to fast
12
Scan speed
0~255
slow to fast
13
Colour speed
0~255
slow to fast
14
Size
0
Original size
1~255
Small to large (120 = original)
Maintenace / cleaning
Always disconnect from mains before cleaning/opening the laser. You can open the device by
removing the top: remove the mounting bracket (4 quick locks), the 5 Philips screws, and the eye
bolt.
Regularly clean the interior from dust, especially ensure operation of the fans. To clean the mirrors,
ideally use acetone and lens cleaning paper (fold paper to get an edge with which to clean the
mirrors). If not available, you can also use window cleaner, and a paper towel. Be careful, even light
scratches reduce the output power of the laser; always clean with strokes in one direction, to
minimize the effect of scratches. Mirrors need cleaning, when a “halo” is noticeable around the beam,
or an unusual high amount of diffuse light can be seen inside the device. When fog fluid condenses in
the device, clean all traces, and rearrange the position of fazer and/or laser.
Technical specifications
•
Output power (at the laser):
RS 800 G: min. 550mW, max. 800mW,
>550mW, 532nm green
RS 800 RGY: min. 600mW, max 800mW,
>250mW 532nm green, >350mW 655nm red
RS 1000 RGB: min. 750mW, max 1000mW,
>200mW 532nm green, > 300mW 655nm red, >250mW 445nm blue
•
Lasersources:
aircooled DPSS laser (green), laser diode (blue with RGB, red with RGB and
RGY models)
•
Laser class:
4
•
Modes:
ILDA, DMX 512, auto, music active
•
ILDA:
25pin ILDA standard Sub-D shaped 25pin connector
•
Galvos:
50k scanspeed
•
DMX 512:
14 channels
•
Patterns:
160
•
Scanangle:
set to ca. 40° optical (60° max)
•
Beam:
ca. 3mm/1mrad
•
Accessories:
power cable, key switch, interlock plug, manual, safety cord
•
The laser comes in a flightcase.
•
Input voltage:
AC 110~120V or 220~240V switchable 50/60Hz
•
Power consumption:
120W
•
dimensions:
550 x 320 x 310mm (W x D x H)
•
Weight:
15kg Laser,
total:
28kg
(with
flightcase)
•
Operating temperature:
10°-35°C
•
Loudness:
<70dB
Change scanner
Unscrew UK M6 screws and disconnect signal cable.
Loosen M4 x 10 screw and remove galvo.
Insert galvo, reconnect and fix signal cable.
Rotate galvo to center projection. Fix galvo.
