User manual: Pro-700RGB
Rev: 01/2009
Page 6 of 9
Technical specifications
•
Output power:
typical
:
700mW, guaranteed
:
470mW, 100mW 632nm green,
70mW 473nm blue, 300mW 650nm red
•
Lasersources:
aircooled DPSS laser
•
Laser class:
4
•
Modes:
ILDA, DMX 512
•
ILDA:
25pin ILDA standard Sub-D shaped 25pin connector
•
Galvos:
50k scanspeed
•
DMX 512:
16 channels
•
Patterns:
160
•
Scanangle:
set to ca. 40° optical (60° max)
•
Beam:
ca. 3mm/1mrad
•
Accessories:
power cable, key switch, interlock plug, manual, safety cord
•
The laser comes in a flightcase.
•
Input voltage:
AC 100~240V 50/60Hz
•
Power consumption:
145W
•
Size:
670 x 380 x 270 mm (W x D x H)
•
Weight:
20kg Laser,
total:
35kg
(with flightcase)
•
Operating temperature:
10°-35°C
•
Temperatur:
10°-35°C
Change scanner
1.
Unscrew UK M6 screws and
disconnect signal cable.
2.
Loosen M4 x 10 screw and remove
galvo.
3.
Insert galvo, reconnect and fix
signal cable.
4.
Rotate galvo to center projection.
Fix galvo.
Adjustable mirror mounts
1.
Loosen setscrews, then adjust with X/Y
adjustable screws. Make sure beam is
centered on scanner mirrors.
2.
Adjust Z-screw simultaneously.
3.
Tighten setscrews.
4.
When combining beams (RGY/RGB
laser), first make sure the beams are
(roughly) on the same spot on the
mirrors/dichros. Then use a test pattern
(e.g. rectangle) to do fine adjustment.
For adjustments, always turn output
power down (if possible).
