User manual: Pro-700RGB
Rev: 01/2009
Page 5 of 9
ILDA mode
When an IDLA compatible interface is connected to the laser, the laser is
automatically switched to ILDA mode. Output is then controlled from a PC running
software.
The laser uses pins 4 and 17 of the IDLA signal to detect the presence of an ILDA
interface.
Further information can be found in the software manual.
DMX mode
Channel
DMX512 value
Function
1
brightness
0~255
0-100% brightness
0~1
No change
Single colour/RGY: strobe
2~255
Strobe from slow to fast
0~25
Original colour
26-207
Colours
2
RGB: colour
208~233; 208~233
Colour change; colour flow
0~42
Pattern group 1
43~85
Pattern group 2
86~128
Pattern group 3
129~171
Pattern group 4
3
Pattern group
172~214
Pattern group 5
4
Pattern
0~255
32 patterns
5
Horizontal rotation
0~255
slow to fast
6
Vertical rotation
0~255
slow to fast
7
Z rotation
0~255
slow to fast
8
Horizontal move
0~255
slow to fast
9
Vertical move
0~255
slow to fast
10
Horizontal stretch
0~255
slow to fast
11
Vertical stretch
0~255
slow to fast
12
Hor. and vert. stretch
0~255
slow to fast
13
Drawing speed
0~255
slow to fast
14
Point draw
0~255
slow to fast
15
Scanspeed
0~255
slow to fast
0~1
Original size
16
Pattern size
2~255
Size (120= original)
Maintenance / cleaning
Always disconnect from mains before cleaning/opening the laser. Regularly clean the
interior from dust, especially ensure operation of the fans. Use a sponge with
alcohol, rather than wet cloth or other chemical liquid, to clean the mirrors. Be
careful, even light scratches reduce the output power of the laser. Mirrors need
cleaning, when a “halo” is noticeable around the beam, or an unusual high amount
of diffuse light can be seen inside the device.
