Manual: Evolution Series ES-600B
page 7 / 18
8. Operation
1. Connect the power cable to the device and then to the mains
2. Press ‚ON‘ to switch on your device
3. Your device runs in
auto mode
:
4. Your device runs in
music mode
:
5. Control the music-sensitivity by the trim pot at the front side of the device. The LED is
flashing when the device is triggered.
6. Your device runs in
DMX mode
if ‘10‘ is switched off:
7. Connect a DMX controller to operate the laser.
8. Use the switches 1 - 9 to set the DMX address of the laser. Each switch represents a num-
ber. To define a number use the preceding number and multipy it by 2:
The laser uses 12 DMX channels, so make sure that the next device uses an address that doesn’t
overlap with this range.
Switch
1
2
3
4
5
6
7
8
9
10
Number 1
2
4
8
16
32
64
128
256
Mode Switch
