Manual / Bedienungsanleitung: EL-200 RGY
Version / Stand: September 10
Page / Seite 5 of / von 10
The address is the sum of all activated numbers, see the following example settings (the white
rectangle represents the position of the switch)
:
Addr
switch
addr
switch
1
65
17
113
The laser uses 10 DMX channels, so make sure that the next device uses an address that doesn’t
overlap with this range. E.g. when using address 1, make sure the next device uses at least address
number 11.
Channel
function
1
mode: 0-69 Laser off; 70-209 sound mode; 210-255 DMX
mode
2
patterns / animations
3
strobe (with increasing speed)
4
Pointspeed
5
horizontal movement*
6
vertical movement*
7
zoom / size*
8
Colour: 1-39 yellow; 40-79 red; 80-119 green; 120-159
original pattern; 160-199 colour change
9
Reset: above 200 (shortly)
10
Colour effect channel: 1-79 draw (increasing) part of the
pattern; 80-119, the same, automaticallywith increasing
speed; 120-255 change colours.
Please note, that not all effect channels work with every pattern.
E.g. you can’t change
position with dynamic patterns, or move a vertical line in y direction, etc.
Maintenance / cleaning
Always disconnect from the mains when the device is not in use or before cleaning it.
Open the device by removing the 2 upper screws on one side panel (one front and one back), then
bend side panel outward and slide out the top. Remove any deposits of dust, especially at the fan.
Check for condensed fog fluid inside. If so, clean and rearrange the position of laser and/or hazer.
Mirrors need cleaning when a “halo” is noticeable around the beam or an unusual high amount of
diffuse light can be seen inside the device.
Clean the mirrors with window cleaner and a paper
towel.
Never look directly into the light source. Always disconnect from the mains when the
device is not in use or before cleaning it.
