TESTING YOUR SETUP
SECTION TW
O
Page 12
LaserShield
®
Instant Security System
OWNER’S MANUAL
Testing your LaserShield
®
and RAPID
RESPONSE MONITORING SERVICE
Until you have completed this test process, your
alarm monitoring will not be in effect. Follow
these simple steps to complete a successful
test:
If you receive an immediate confirmation for
service using the Internet, you may test your
service immediately. If you use fax or mail to
activate your monitoring service, wait until a
LaserShield
®
Customer Care representative
calls you to begin your test.
Press a panic button on your Keychain
Remote, MAU or WDU. Allow the siren to ring
for 10 seconds before disarming.
RRMS will call you to confirm the successful
communication between your System and
Rapid Response. You will be asked to provide
your 5 digit Passcode (located on your
emergency card) and to verify that you are
ready to begin fully active monitored alarm
service. Please contact LaserShield
®
Customer Care if your test was not
successful.
1.
2.
3.