Laserscope GreenLight HPS, Руководство оператора

Страница: 33 / 74

Section 2
System Installation
System Installation 9
2.1 RESPONSIBILITY
This section provides general guidelines for the installation of the GreenLight
HPS
™
laser system. This laser system has specific installation requirements.
It is the customer’s responsibility to fulfill these requirements prior to the
installation of the system. Failure to do so can result in intermittent operation
and even damage to the laser system. Please read the following information
carefully.
S
CAUTION: The crated system should be stored in a protected
area in temperatures between 50 ° F (10 ° C) and 104 ° F (40 ° C).
Laserscope’s Responsibility
A Laserscope Service Representative will install the laser system. Upon
arrival at the installation site, the representative will perform the following:
1.
Verify appropriate power.
2. Uncrate the system and inspect for damage.
3. Perform all optical, electronic, and system checks necessary to bring the
laser into operation.
4. Inventory all shipped accessories.
Customer’s Responsibility
Provisions for proper power must be made prior to the receipt and
installation of the system. Return visits by service personnel for installation
will not be covered under warranty. Upon completion of the pre-installation
site preparation, call Laserscope to check shipment date and schedule
installation of the system.
Because the GreenLight HPS
™
system uses standard electrical service and
has built-in cooling systems, installation requires minimal site preparation.
S
CAUTION: Do not attempt to turn on the system until it has
been installed and tested by a Laserscope Service Engineer.
Severe damage to the system will result.