ICS-KP14 Instruction Manual
01850-53-000
Page 13 of 18
Issue 3 19 January 2021
7
Programming
The keypad should be programmed before use to set the desired operating times and the codes for
programming and entry.
Ensure the keypad power is on (blue PWR indicator lit).
To put the keypad into program mode, type the following:
Note that ‘1234’ is the factory default program code. This may have been changed following
installation.
The yellow PRG light will flash slowly to indicate the keypad is in program mode.
Now select one of the following choices by pressing the appropriate key on the keypad:
Change User Code
Change Program Code
Change Override Time
Change Door Unlocked Time
Enter Test Mode
Exit and return to normal operation
1 Change User Code, 2 Change Program Code
When you have selected one of these, the PRG light will flash quickly to show that the keypad is ready
to accept the new code. Type in the new four-digit numerical code, followed by #. The code will be
stored by the keypad, and it will return to the Program Mode menu above, with the PRG light flashing
slowly, ready for the next choice.
Note that if you change the program code, you will need to enter the new code in place of 1234 shown
above to enter program mode next time.
