SmartVision-Laser
11
B
C
2,5 m
< 2,5 mm = OK
LASER
LASER
LASER
LASER
LASER
EN
3
Slope mode
Do not release the transport restraint, set the ON/OFF switch
to „OFF“. Select and switch on the laser with the selection
button. Sloping planes can now be measured. This mode
cannot be used to perform horizontal or vertical levelling
as the laser lines are no longer aligned automatically. The
LED lights constantly red.
Checking the horizontal line
Position the device about 5 m
from a wall and switch on the
cross laser. Mark point B on the
wall. Turn the laser cross approx.
2.5 m to the right and mark
point C. Check whether the
horizontal line from point C is level with point B to within
± 2.5 mm. Repeat the process by turning the laser to the left.
Checking the vertical line
Position the device about 5 m from a wall. Fix a plumb bob with
a line of 2.5 m length on the wall, making sure that the bob can
swing freely. Switch on the device and align the vertical laser to
the plumb line. The precision is within the specified tolerance if
the deviation between the laser line and the plumb line is not
greater than ± 2.5 mm.
Regularly check the calibration before use, after
transport and after extended periods of storage.
!
