- LS6001 remains in very low power mode with GPS and GSM turned off until it
detects movement using the internal accelerometer. In this condition, the current
consumption of the device is of a few micro-amps, reducing the battery
consumption substantially to zero. Once a movement is detected, the system
enters the SEARCH mode, activates the short-range receiver and waits to detect
an associated TAG.
If the transponder TRA200 is recognized, the system will go into MOVEMENT
mode and will remain in this state until the vehicle is running and for the next three
minutes it stops. On the contrary, if LS6001 does not detect the presence of a
valid transponder, it enters the ALARM mode and sends the following SMS
messages.
19
SYSTEM FUNCTIONING
- LS6001 as soon as it locates its position, it sends to all the authorized numbers
an SMS containing the link of google.maps through which it is possible to find the
position on the map.
1)
:
ALARM SMS
BATT
Backup
battery condition
of LS6001
StopN:
command to be
sent to switch off the
alarm mode
1-99 minutes:
set the number
of minutes between
a position message and
the next one
(
30 minutes)
setting factory
- LS6001 remains in the alarm condition until a STOP
command is received (see page 8).
The link of the location is in a format compatible with the most used browsers. It
should not be open through the Maps application because the format could not
be supported.
2)
:
POSITION SMS
Press on the BLUE
link to display the
device position on the
map
Message without GPS
position
OK
OK
OK