sequences normally will not be interrupted.
Limits
DMX base address 1 – 512
Intensity 0 – 99
Orientation 0 – 7
Limits will be controlled automatically by the panel. If trying to set a value beyond the limits,
the panel automatically corrects to an allowed value during input.
Intensity
For the projector, this value should be set to 99.
Orientation
There are 8 different values possible, allowing all possible projection orientations.
This is important for back projections or if it is not clear how the projector is installed at
the location.
0: normal
1: X invert
2: Y invert
3: X and Y invert
4: X and Y changed
5: X and Y changed and X invert
6: X and Y changed and Y invert
7: X and Y changed and both inverted
2.2 Message center
8
If any error condition occurs, a code will be displayed on the status-LEDs (see table).
Not all errors will cause a stop of playback.
Errors from the memory card (read/write) will cause a total shutdown of the player.
If there is no card or the card is not inserted correctly of if there is no right format or file
system, the player functions will be shut down.
When there is no file allocated to a selected show number, this is no error condition and
the player
will switch the output to Pause (Shown umber 0 PAUSE).
When the accessed show file is not valid or corrupted, the playback will be switched off.
All other functions keep running and the selection of another show is possible.
Ready
DMX
Data
Error
===========================
- -
Yellow -
No MMC/SD-card
- -
Yellow Red
File system FAT16 not found
Yellow -
Yellow Red
Data error when reading MMC/SD-card
Yellow -
Yellow -
File not found or invalid file
Yellow - -
x
No DMX-signal
Yellow
Green -
-
Ready
