2.3 DMX channels assignmet
9
Channel1: Show select L
This channel is used for show selection; one of the first 16 shows (including Pause) can
be selected.
Channel2: Show select H
16 banks of shows, 16 shows each, 256 shows can be selected using this function.
Channel3: Size (projection size)
When you change size by the use of DMX-control, a fader position of 0 (minimum) can
cause a standing laser beam. This can be a
dangerous
condition!
DMX only allows a refresh rate of 50 Hz.
Moving a control fader fast will result in jumps of the display settings.
Channel4: Offset X (horizontal position)
A value of zero results in the maximum negative offset.
128 is the center position and 255 is the maximum positive offset.
When changing this value via DMX, the projected display can jump, because DMX
signal rate is slow.
Channel5: Offset Y (vertical position)
See Offset X.
Channel6: Frame repeat
Shows in ILDA-format do not contain any timing information. When all frames of a show
are outputted one after the other, the animation speed is too fast.
By repeating every frame a number of times, the speed of the animation movement can
be controlled. Values by DMX-control are 1 to 16.
2.4 Memory card (Compact Flash card)
All Compact Flash cards up to a maximum capacity of 2 Gigabytes (!) can be used.
2.4.1 Important
The card has to be formatted with FAT16 file system only.
The manufacturer recommends the use of high quality cards.
No-name cards can cause read errors.
All cards shipped together with the equipment are formatted correctly and must NOT
be reformatted.
2.4.2 Caution
