2. SD Card Controlling Mode
2.1 SD CARD Controlling Settings Panel
The panel can be used to access some important parameters for the ILDA projector.
If the memory of the panel is empty, it displays “Err” at power-on.
At normal function, if parameters are set correctly, the panel displays the actual DMX
base address, for example “001”.
There are 3 keys from left to right:
1. FUNC
By pressing
FUNC
, the actual parameter for changing is selected.
There are
2
parameters currently available:
“Adr” = DMX base address
“Ort” = orientation of the projection
2. SEL
After selected the parameter with
FUNC
, press
SEL
and the current stored value will be
displayed.
By pressing
SEL
again, the digit for changing will blink.
Pressing Select multiple times will activate all digits by blinking one after the other.
3. Up
7
Use this key to change the current number in the blinking digit. The number will be
increased.
When reaching the maximum number (9), the number will be start from zero again.
Example:
Set DMX base address to 200.
Press “
FUNC
” until “Adr” blinks
Press “
SEL
” until current value is displayed and right digit blinks
Press “
Up
” until “0” is reached.
Press “
SEL
” to go to middle digit
Press “
Up
” until “0”.
Press “
SEL
” until left digit blinks
Press “
Up
” until “2” is reached.
Press “
FUNC
” for exit this parameter. The value is stored automatically.
All values are stored and activated when exit the parameter input by pressing “
FUNC
parameter. The value is stored automatically.
After not changing anything in the parameter input routine, the panel will return to main
routine after about 10 seconds without storing value to memory.
Note that playback of longer shows may be interrupted (stopped) when changing
parameters at the panel during show output. Display of single frames of short
