Laser Cut Planes HogNose, Инструкция по сборке

Страница: 4 / 30

Suggested Items needed to Complete this Model
Many of the suggested items listed below are available at your local hobby shop. For your convenience,
lasercutplanes stock most the power system components and some of the building supplies required
to complete this kit. If you have difficulties sourcing any of these items locally, please visit our website,
lasercutplanes.co.uk to purchase the items necessary to complete your model.
Suggested Electronics
☐ RC transmitter DSM2/DSMX with at least 3 channels
☐ Receiver/ESC/Servo brick (AR6410 or equivalent)
☐ Motor/Gearbox (PKZ3624)
☐ Propeller, 130mm x 70mm (EFL9051)
☐ LiPo battery, 120 - 160 mAh 3.7V
This assumes the use of Spektrum electronics. Other systems may be used.
Covering Film Requirements
Any high-quality covering film may be used to finish this model, superior results will be achieved by
using the lightest covering film possible. (Solite currently available to purchase with the kit).
☐ 1 - Pack of Solite sufficient to cover complete plane
Available in Transparent Red, Blue and Green. (other colours available to order).
We recommend the use of Acrylic paint to finish the bare wood parts of the model. This may be either brushed or
airbrushed on.
Required Building Supplies and Tools
☐ CA glue, medium,
☐ CA glue, thin,
☐ CA glue accelerator
☐ Hobby knife with supply of #11 blades
☐ Sanding block with 400 and 600 grit paper
Building Supplies and Tools
☐ Covering iron and heat gun
☐ Needle nose pliers, small
☐ Clear tape, 1/2 in.
☐ Velcro for mounting battery
☐ Masking tape
☐ Solite covering film
Optional Building Supplies and Tools
☐ Balsa filler (HCAR3401)
☐ Modeling clay (ballast)
☐ CA glue de-bonder (PAAPT16)
☐ Required Building Supplies