Laser Atlanta SpeedLaser S, Руководство пользователя

Страница: 27 / 40

28
Test Mode
Performing the Self-Test
MENU A
# Action Key
1 Turn On PWR
2 Select MENU MENU
3 Select TEST MODE A
The self-test performs the following functions:
•
The SpeedLaser ® setting are restored to their factory default
values.
•
The software Part Number and Version are displayed in the
LCD.
•
The program and storage memories are tested.
•
The battery voltage is displayed on an E mpty - - - - F ull scale.
•
The speed and distance units of measure are displayed on the
LCD. (Note: These units are pre-configured at the factory and
cannot be set by the end-user.)
•
All LED segments in the HUD are cycled through the numerals
1 to 9 and then finally displayed as 8888.
•
Range (distance measurement) mode is automatically turned on.
This allows the operator to perform the range (chronometer) and
alignment checks (
see procedure starting on page 19 .)
If any of the diagnostic functions fail, a failure warning will be displayed
on both the LCD and in the HUD. A warning tone will sound and the
SpeedLaser
®
will prohibit firing of the laser. The operator should
attempt to power the unit down and back on and run the self-test again.
PWR MENU BACK
A B C D
FIRE
LCD HUD
RESET & TEST Pg A
P/N 50103-E190 v4.86
Memory-OK PWR:E---*F
Units: ft,mph NEXT<D