9
Copyright 2005 Laser Arts
15.
Cut 2 pieces of triangle stock about 2” long. Glue them to the stab as shown in the image below.
16.
With wet sandpaper, lightly sand a section of the CF boom, starting about 5-5/16” forward of the small end going back. This is to
make the bond between the stab and the boom stronger. Make sure the boom is dried before continuing.
17.
Glue the stab to the boom, with the leading edge of the stab 5-5/16” forward of the boom end. (the smaller end of the boom) We
recommend using epoxy for this joint to make sure it is good and strong. Make sure it stays on straight while drying.
18.
Glue the other grooved ¼” balsa pieces from step 13 to the vertical fin as shown in the image below. It goes on the LEFT side if
you are RIGHT handed or on the RIGHT side if you are LEFT handed.
