Larzep HN-360, Руководство пользователя

Страница: 2 / 12

2
Instruction Manual
Hydropneumatic Trolley Jack“HN-360”
INDEX
1. BEFORE USING THE EQUIPMENT ------------------------- 2
2. ESSENTIAL SAFETY REQUIREMENTS----------------------- 2
3. TECHNICAL FEATURES--------------------------------- 3
•
START UP
•
ENVIRONMENTAL CONDITIONS
4. START UP ------------------------------------------- 3
5. MAINTENANCE--------------------------------------- 4
6. WARRANTY------------------------------------------ 4
7. DECLARATION OF CONFORMITY------------------------- 5
1. BEFORE USING THE EQUIPMENT.
Before using the hydraulic trolley, read these instructions carefully and familiarise yourself with security pictures.
This manual is a part of the machine so it is obligatory to read it and must be conserved.
The symbols used in this manual are the following:
ATENTION: This symbol depicts a security advert, and shows that we have strictly followed the manual instructions. If we do not
do this, should produce material damage or personal injuries, also lethal damage.
Put the load settled.
Block the load and do not operate behind this.
The omission of these instructions may cause material and personal injuries that LARZEP, S.A. will not be responsible for.
When unpacking check that the hydro pneumatic trolley is not damaged, or that it has loose pieces.
If any anomaly, damage, sign of corrosion, or any fault is found, do not use the equipment, store it in a clean place and where children
can not access it, until the equipment is repaired or replaced.
Never use faulty equipment.
The hydro pneumatic trolley has been designed and fabricated in order to elevate vehicles, the principal groups are:
1- Commands group
2- Lever group
3- Motor-pump group
4- Tank group
5- Cylinder and pistons group
6- Depressor group
7- Chassis-housing group
8- Tank group.
2. ESSENTIAL SAFETY REQUIREMENTS.
•
Do not operate the overpressure valve, which is strapped.(3)
• Before starting the elevation operation, block the vehicle by placing wedges under the wheels.
•
Put the load in a way that stay settled in the cylinder’s piston plate. (5)
•
Settled load.
•
Once the load is elevated, it is necessary to block it, in order to avoid risks.
•
Block the load and do not operate behind it.
• Do not elevate the load in restricted areas in order to avoid the risk of been trapped.
•
During the elevating and descending operations ensure there is nobody under the load.
• Do not elevate load on irregular surfaces, or dipped surfaces, to avoid the risk of dumping.
•
Do not assemble extensions or use spare parts that are not authorised by your dealer or LARZEP, S.A.
• There is the possibility to connect supplies to the piston of 70 mm and 120 mm.