L'Artistico Pellicano M14, Инструкция по установке, эксплуатации и обслуживанию

Страница: 24 / 32

L’ARTISTICO SRL | EN 24 Cod. 40014 | Rev. 04 | 08/06/2018
Voltage variations greater than 10% of the nominal value, may affect
the proper functioning of the product causing anomalies to its
electrical system.
CAUTION: The electrical system must be fitted
with a suitable earth circuit conforms to the 72/23 EEC
standards, 93/98 EEC.
JACK POWER
CABLE
SLOT 2
REMOVABLE FUSE
ON / OFF
SWITCH
19. EMERGENCY CONTROL PANEL
It comes complete with its plasterboard recessed box. The control
panel acts as a receiver for the remote control and must be operated
manually only for emergency operation in the event of breakdown or
loss of the remote control.
WARNING: it should be positioned so that it is
visible and accessible. It may also not be visible on the
external plasterboard as it communicates via radio with
the remote control.
20. AIR COMBUSTION INPUT
The air intake for combustion differs according to the type of fuel
used.
Fit the supplied control valve on the air intake collar.
USE WITH PELLET OR MIX PELLET/WOOD
The combustion air in this case is automatic and forced through a fan
that aspirates the air from the outside socket and the environment and
pushes it into a tube to the pellet brazier.
Always provide an air intake grill at the bottom of the coating around
the fireplace at least 600 cm2.
Close the rear air inlet of the chimney with the valve supplied.
USE OF THE APPLIANCE EXCLUSIVELY WITH WOOD
WITHOUT POWER SUPPLY
The combustion air entry in this case occurs in natural circulation
through the Ø 80 mm collar, which can also be directly connected to
the outside. Use the inlet relief valve supplied with the chimney and fix
it to this inlet to regulate combustion: by opening or closing the valve
the height of the flame is adjusted.
Always provide an air intake grille at the bottom of the mantle around
the fireplace at least 600 cm2 for convection air.